GovWire

3. ELV pre-acceptance, acceptance and tracking

Environment Agency

October 19
12:35 2023

1. In all cases you must reassess the information required at pre-acceptance on an annual basis. The information required and the assessment made at the pre-acceptance stage is to make sure you:

  • only accept ELVs that are suitable for the site
  • avoid accumulating ELVs
  • have enough storage and treatment capacity

2. You must implement ELV pre-acceptance procedures so that you know enough about ELVs before they arrive at your facility. You need to do this to assess and confirm the ELVs are technically and legally suitable for your facility and processes. Your procedures must follow a risk-based approach, considering:

  • the source and nature of the ELV
  • its hazardous properties, for example, whether it is a combustion vehicle or electric end of life vehicle (EELV)
  • potential risks to the environment (for example, from fire)

3. You must get the following information in writing when you agree to accept an ELV:

  • details of the ELV holder, including name, address and contact details
  • the specific source of the ELV
  • a description of the ELV including its composition and quantity
  • the List of Waste codes (European Waste Catalogue (EWC) code)

If the ELV has already been depolluted, you should request evidence to show this has been done. A certificate of destruction (COD), a visual check, declaration or some other evidence may help to confirm that depollution has been carried out.

4. You must consider whether any of the specific ELVs you are permitted to receive have properties that can pose unacceptable risks to the site or process. For example, damaged batteries can present a chemical, electric shock and fire risk.

5. You should establish a list of these ELVs and procedures for managing the risks they pose.

6. You must keep pre-acceptance records for at least 3 years in a suitable ELV tracking system following receipt of the ELV .

7. You must reassess the information required at pre-acceptance if the ELV received does not conform to the pre-acceptance information.

3.2. ELV acceptance and tracking

1. You must implement ELV acceptance procedures to check that the ELV received matches the information you obtained during pre-acceptance. This is to confirm that the waste is as expected and that you are permitted to accept it.

2. If not, you must confirm that you can accept it as a non-conforming waste, or you must reject it. If you are rejecting an undepolluted ELV, you must follow the guidance on the procedure for rejecting hazardous loads.

3. Your procedures should be documented and auditable and must follow a risk-based approach, considering the ELVs:

  • source, nature, and age
  • hazardous properties
  • potential to contain persistent organic pollutants (POPs)
  • potential risks to process or occupational safety, and to the environment (for example, from odour and other emissions)
  • previous holders and your knowledge about them

4. If you have not received any pre-acceptance information, you must assess the load to make sure it is technically (and legally) suitable for the site. Your checks and assessment must be risk-based considering, for example, the:

  • hazardous properties of the ELV
  • risks posed by the ELV in terms of process safety, occupational safety, and environmental impact

Storage areas

5. All relevant storage areas (quarantine, reception and general) and treatment processes in your facility must have the physical capacity needed for the ELVs you receive. You must not receive ELVs if this capacity is not available. The amount of ELVs you receive must also comply with storage limits in your permit.

6. The ELV offloading, reception, treatment and quarantine areas must have impermeable surfaces with a sealed drainage system. This system must collect all surface water run?off and channel it to a blind sump unless you can lawfully discharge it in another way.

ELVs and treatment areas should be stored under cover to prevent ingress of rain and surface water.

You should keep clean surface water from roofs separate from contaminated waters.

7. You must clearly designate a materials reception area (or areas). Staff controlling the inspection, reception and validation of materials at the installation must be trained in their respective roles.

Waste acceptance

8. You must assess the weight of each load of ELVs on arrival to confirm the quantities against the accompanying paperwork. This is unless you have alternative reliable systems (for example, based on established data). You must record the weight in a suitable ELV tracking system.

9. You must check and validate all transfer documentation and resolve discrepancies before you accept the ELVs. If you believe the classification and description of the incoming ELVs is incorrect or incomplete, then you must address this with the customer during ELV acceptance. You must record any non-conformances. If you have assessed the ELVs as acceptable for on site storage or treatment, you must document this.

10. You must have clear criteria that you use to reject non-conforming ELVs. You must also have a written procedure for recording, reporting, and tracking non-conforming ELVs, including notifying the relevant customer or ELV producer to prevent reoccurrence.

Baling ELVs or components

11. If you are baling ELVs, you must make sure they are fully depolluted before baling.

Quarantine storage

12. You must establish quarantine areas for materials that are prohibited, awaiting full inspection, or awaiting testing or removal.

13. Quarantine storage must be for a maximum of 14 working days. For some limited and specific cases (for example, gas cylinders) you can extend the quarantine storage time if the Environment Agency agrees.

14. You must have written procedures for dealing with waste held in quarantine, and a maximum storage volume.

15. Quarantine storage must be separate from all other storage and clearly marked as a quarantine area.

16. You must identify and isolate gas cylinders and other prohibited items to remove them from the ELV stream. You must store gas cylinders in locked cages. Where possible, you must send prohibited items back to the appropriate owner.

3.3. ELV tracking

Related Articles

Comments

  1. We don't have any comments for this article yet. Why not join in and start a discussion.

Write a Comment

Your name:
Your email:
Comments:

Post my comment

Recent Comments

Follow Us on Twitter

Share This


Enjoyed this? Why not share it with others if you've found it useful by using one of the tools below: